ferrojack.blogg.se - Qnap surveillance station question mark on test

#QNAP SURVEILLANCE STATION QUESTION MARK ON TEST 720P#
#QNAP SURVEILLANCE STATION QUESTION MARK ON TEST INSTALL#

Tip: What if I forget the camera settings? You will then be able to view the monitoring image.Ħ – GO to ‘Network -> General” and check the IP settings of the camera.ħ – Change Ip Adress configuration as you plan, and should be look like this:

#QNAP SURVEILLANCE STATION QUESTION MARK ON TEST INSTALL#

Lilin Camera Default Ip adress is 192.168.0.200, so type explorer this:ĥ – The first time you access the configuration page by the IE browser, remember to install the ActiveX control if asked. The default login name and password of Lilin camera is root / adminĤ – ENTER the web configuration page of the IP camera.

#QNAP SURVEILLANCE STATION QUESTION MARK ON TEST 720P#

Note: The default IP of Lilin Hybrid D/N 720P CMOS HD IP camera is 192.168.0.200 The default gateway should be set as the LAN IP of the router (192.168.2.1 in our example). Enter the IP address of the camera as 192.168.2.95. You will then be able to login the configuration page of the camera with the IE browser. I’ll use Lilin “Hybrid D/N 720P CMOS HD IP Camera / IPG012ESX” with Onvif Support at this Example:Ģ – TAKE out the CD-ROM from the camera package of your Lilin camera package and install the IP Finder Program.ģ – Set the IP address of the camera so that they are in the same LAN as the computer. In this example:ġ – Configure the IP address for both IP cameras by the following steps. Assign fixed IP addresses for the NAS and the IP cameras. Your computer, the NAS, and the IP cameras should be installed to the same router in LAN.

The IP address of your router and the wireless SSID.

Write down your plan of the home/office network before starting to set up the surveillance system. I – Plan Your Home/Office Network Topology III – Configure the Surveillance Station on the QNAP NAS I – Plan your home/office network topology